JLG 150HAX Operator Manual - Manual (Page 89)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121213 – JLG Lift – 6-11
6.3 OPERATOR MAINTENANCE
NOTE: The following numbers correspond to those in Figure 6-
4., Operator Maintenance & Lubrication Diagram.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION
UNDER NORMAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT
OPERATIONS AND/OR EXPOSED TO HOSTILE ENVIRONMENTS OR CON-
DITIONS, LUBRICATION FREQUENCIES MUST BE INCREASED ACCORD-
INGLY.
NOTE: It is recommended as a good practice to replace all filters
at the same time.
1. Torque Hubs
Lube Point(s) - 1 Fill Plug per hub
Capacity -
Lube - EPGL
Interval - Check oil level at side plug on hub weekly.
Change after first 3 months or 150 hours then every 2
years or 1200 hours of operation.
Comments - Place Fill port at 12 o’clock position and
pour lubricant into fill port until it just starts to flow out of
check port when it’s at the 3 o’clock position.
Table 6-13. Lubrication Specifications
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of 350° F
(177° C). Excellent water resistance and adhesive qualities, and
being of extreme pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classifica-
tion GL-5 or MIL-Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424.
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104.
Diesel - API CC/CD class, MIL-L-2104B/MIL-L-2104C.