JLG M4069 Operator Manual - Manual (Page 56)

SECTION 4 - MACHINE OPERATION
4-2 – JLG Lift – 3121638
4.4 LEVELING JACKS
Once the leveling jacks leave the stowed position (fully
retracted) but are not fully extended, the lift and drive functions
are cut out.
After all 4 jacks are extended and touch a solid surface only the
drive function is cut out. Drive function is restored once the
jacks are stowed (fully retracted) again.
4.5 PLATFORM EXTENSION
The machine is equipped with a mechanically extendible deck.
To extend the deck, lift handle up on the left and right side of
the platform to release the latch and use the handle to push the
extendible deck out. When the deck reaches the end of its
travel, push handle down to latch, this will lock and hold the
deck in place. To retract the deck, reverse operation.
4.6 PLATFORM HANDRAILS FOLD DOWN PROCEDURE (IF
EQUIPPED)
1. Remove the two pins from platform extension gate
and fold gate to the left side handrail.
2. Remove the pin from extension left side handrail, lift
up and fold down handrail onto platform deck.
3. Remove the pin from extension right side handrail, lift
up and fold down onto platform deck.
4. Remove the two pins from rear handrail, lift up and
fold gate down onto platform deck.
5. Lift up left handrail, fold handrail down onto platform
deck.
6. Lift up right handrail, fold handrail down onto plat-
form deck.
4.7 STEERING
Position thumb switch on drive/lift/steer controller to right for
steering right, or to left for steering left.
TO AVOID LOSS OF TRAVEL CONTROL OR UPSET ON GRADES AND SIDE
SLOPES, DO NOT DRIVE MACHINE ON GRADES OR SIDE SLOPES EXCEEDING
THOSE SPECIFIED ON WARNING PLACARD AT PLATFORM.