JLG G10-43A Parts Manual - Manual (Page 160)

ENGINE & ATTACHING PARTS
G9-43A/G10-43A 91514001 4-38
Figure 4-8 Fuel Tank & Lines
PY6270
1
3
9
8
7
4
5
6
22
10
11 12
13
15
19
12
11
16
20
21
17
14
2
21
17
14
2
18
105
108 103
107
115
110
111
113
120
201
204
102
202
102
202
203
112
302
301
304
303
304
401
402
403
RETURN LINE
(FROM LH SIDE OF ENGINE)
SUCTION LINE
(TO RH SIDE OF ENGINE)
NOTE: S/N 0160020150 & AFTER
1. APPLY LOCTITE ® 30512 TM (0100093) ON ALL ADAPTER THREADS
UP TO GASKET START AT BOTTOM OF THE THREADS; 360
DEGREES. AIR DRY FOR 3 TO 4 MINUTES ON BOTH MATING PARTS.
2. APPLY 1/2 IN. ALL THE WAY AROUND THE FILLER NECK THREADS.
APPLY THE ADAPTER TO THE FILLER NECK ON THE TANK.
3. ONCE ASSEMBLED, NO FUEL SHOULD BE ADDED FOR 8 HOURS.
NOTE: BEFORE S/N 0160020150 WHEN USING FUEL CAP ADAPTER KIT, 2902446
1. COAT ALL THREADS OF ADAPTER (ITEM 301) AND SET SCREWS (ITEM 303)
WITH LOCTITE ® 641 TM (14404978) BEFORE INSTALLING FILLER NECK
ADAPTER.
2. HAND TIGHTEN SET SCREWS JUST UNTIL RESISTANCE IS FELT.
OVERTIGHTENED SCREWS WILL DISTORT PLASTIC THREADS.
Before S/N 0160040675
excluding 0160040468 & 0160040672