Eppendorf Thermoblock for slides DC - Manual (Page 7)

7
6. Close the lid and push down the 2 pressure points on the front edges of the
lid. It is absolutely necessary to ascertain that the lid has been correctly
closed prior to starting the device.
In the case of the Thermomixer comfort, block identification occurs after the
exchangeable Thermoblock for slides DC has been correctly positioned.
This results in an automatic limitation of maximum possible rotational speed
(1400 rpm) and temperature setting (70 °C).
In the case of the ThermoStat plus there is no block identification function
for technical reasons. Please set for max. temperature of 70 °C.
7. After the incubation step, open the Thermoblock for slides DC lid and
unscrew the pressure plate (caution: hot plate) by alternating between both
screws.
An Eppendorf hybridization frame must be positioned above the microarray on
the slide surface in order to carry out the reaction.
In the case of using DualChip™ microarrays from Eppendorf, hybridization
frames are already placed on the slides.
Four slide positions are provided on the exchangeable Thermoblock for slides
DC.
4 Application
3 Mounting / 4 Application
ThermoblSlides_DC.fm Seite 7 Dienstag, 16. August 2005 8:27 08