IKA EUROSTAR 20 high speed control - Manual (Page 3)

3
Contents
EC-Declaration of conformity 3
Note for USA (FCC) 3
Note for Canada (IC) 3
Explication of warning symbols 3
Safety instructions 4
Correct use 5
Unpacking 5
Drive 6
Motor protection
6
Speed – normal operation 6
Speed – overload operation 6
Output shaft 6
Speed display 6
EC-Declaration of conformity
We declare under our sole responsibility that this product corresponds to the regulations 2006/42/EC and 2004/108/EC and conforms
with the standards or standardized documents EN 61010-1, -2-051; EN ISO 12100-1, -2; EN 60204-1 and EN 61326-1.
Bluetooth
® module:
Directive: 1999/5/EC Standards: EN 60950-1, EN 300 328, EN 301 489-1, -17
Source language: German EN
Commissioning 6
Securing 7
Switching on the instrument
8
Useful information 8
Wireless Controller (WiCo) 8
Interfaces and outputs
14
Maintenance and cleaning 16
Error codes 16
Warranty 17
Accessories 17
Permitted IKA
® stirrer tools 17
Technical data 18
Page Page
Note for USA (FCC)
This equipment complies with Part 15 of the FCC rules. Any changes or modifications not expressly approved by the Manufacturer could void
the user's authority to operate the equipment. This device complies with Part 15 of the FCC rules subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept all interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environ-
ment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Note for Canada (IC)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with Health Canada’s Safety Code 6 / IC RSS-210. The installer of this device should ensure that RF radiation is not emitted in
excess of the Health Canada’s requirement.
Explication of warning symbols
General hazard
This symbol identifies information that is of vital importance for safeguarding your health and safety.
Disregarding this information can lead to health impairment and injuries.
This symbol identifies information that is of importance for the technically correct functioning of the system.
Disregarding this information can result in damage to the instrument or to system components.
This symbol indicates information which is important for ensuring that the operations of the instrument are per-
formed efficiently and for using the instrument. Failure to observe this information can result in inaccurate results.
DANGER
CAUTION
WARNING