Error codes, Maintenance and cleaning – IKA ROLLER 10 digital User Manual
Page 15

15
Error codes
IKA
®
Roller 6/10 basic
In case of a fault, a beep is heard and the “Power” LED fl ashes.
Proceed as follows in such cases:
Switch the device off.
Perform corrective measures as described below.
Perform a restart.
Error
Cause
Effect
Solution
Motor blockage or overload
Motor off
- Switch the device off.
- Reduce the load on the motor and check all moving parts for
freedom of movement.
- Then perform a restart.
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the IKA
®
service department,
- Send the device for repair, including a short description of the fault.
IKA
®
Roller 6/10 digital
The fault is shown by an error code in the display as following if the error occurs, e.g. Er 4.
Proceed as follows in such cases:
Switch the device off.
Perform corrective measures as described below.
Perform a restart.
Error
Cause
Effect
Solution
Er 3
Temperature inside device is too
high
Motor off
- Switch the device off.
- Allow the device to cool down.
Er 4
Motor blockage or overload
Motor off
- Switch the device off.
- Reduce the load on the motor and check all moving parts for
freedom of movement.
- Then perform a restart.
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the IKA
®
service department,
- Send the device for repair, including a short description of the fault.
Food
water containing detergent
Fuels
water containing detergent
Other materials
please consult IKA
®
Spare parts order
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item and designation of the spare part, see www.ika.com,
spare parts diagram and spare parts list
Repair
In case of repair the device has to be cleaned and free from any
materials which may constitute a health hazard.
For this you should use the downloaded print of the "Certifi cate
of compliance" form from the IKA
®
website www.ika.com.
If you require servicing, return the appliance in its original pa-
ckaging. Storage packaging is not suffi cient. Please also use sui-
table transport packaging.
The device operates maintenance-free.
For cleaning disconnect the main plug.
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning agents for
cleaning purposes.
- Do not allow moisture to get into the appliance when cleaning.
- Please consult with IKA
®
before using any cleaning or deconta-
mination methods, other than those recommended here.
Only clean IKA
®
appliances using these IKA
®
approved cleaning
agents:
Dirt
Cleaning agent
Dyes isopropanol
Building materials
water containing detergent,
isopropanol
Cosmetics
water containing detergent,
isopropanol
Maintenance and cleaning