BUSH DAB+/FM/AM Digital Radio TR82DAB - Manual (Page 13)

Bush TR82DAB
13
Using the MW/LW/FM Radio
If the DAB+ digital radio is in DAB+ mode, press the desired frequency band (MW, LW or FM). You may hear
background noise as no stations has been tuned in.
Tuning the radio
To tune into a radio broadcast/station, turn the tuning control left or right until pointer is aligned with the desired
frequency markings on the tuning dial.
When the pointer is horizontal you have either reached the start, or end of the frequency range. Do not attempt to
force the dial further in the same direction.
Adjusting the Volume
To adjust the volume turn the volume wheel, located on the top of the radio. To increase the volume turn it to the
right and to decrease the volume turn the wheel to the left.
Tone Dial
The tone dial is used to alter the audio output of the DAB digital radio between a high (treble) and low (bass)
frequency range. Turn the tone dial right to enhance the high frequency (treble) content of the sound output. Turn
the tone dial left to enhance the low frequency (bass) content of the sound output.
Using Line Out
The signal from the DAB+ digital radio can be connected to another stereo audio device via the 3.5 mm Line Out
Socket on the right hand side of the radio.
You will require a stereo cable which is terminated with connectors which match the sockets on your other audio
device.
Note: The signal level from the line out socket is fixed and cannot be adjusted using the Volume control.