Snorkel S3219E-sn000000+ - Manual (Page 48)

Chapter 10 – Stowing and Transporting
44 S3219E/S4732E – 1500834
5. Use spreader bars of sufficient length to keep the
chains, straps, or cables from contacting the scissors
structure or platform.
When using cables, use rigid corner protectors
at any point where the cable contacts on sharp
corners to prevent damaging the cable.
Careful rigging of the spreaders is required to
prevent machine damage.
6. Adjust the length of each chain or strap so the aerial
platform remains level when raised off the ground.
7. Use the hoist or crane to carefully raise and position
the aerial platform onto the transport vehicle.
Securing for Transport
Use the following procedure to secure the aerial platform
on the transport vehicle.
1. Chock the wheels.
2. Remove all personnel, tools, materials, or other loose
objects from the platform.
3. Properly stow the aerial platform.
4. Place wood blocks under the front ends of the pothole
protection skids to limit excessive loading on the front
drive wheel bearings.
5. Place the lower controls emergency stop switch in
the off position.
6. Turn the battery disconnect switch off.
Caution
Ratchets, winches, and come-alongs can produce
enough force to damage machine components. Do
not over tighten the straps or chains when securing
the aerial platform to the transport vehicle.
7. Use chains or straps to securely fasten the aerial plat-
form to the transport vehicle using the front and rear
tie-down lugs as attachment points. Proper tie-down
and hauling is the responsibility of the carrier.

