RIDGID R83015 - Manual (Page 7)

7
Chuck ............................................................................................................................................... 1/2 in. (13 mm) Keyless
Motor .................................................................................................................................................................. 14.4 Volt DC
Switch ............................................................................................................................................................ Variable Speed
Gear Train ................................................................................................................................................................. 2 Speed
No Load Speed ......................................................................................................................................... 0-400/0-1600/min.
Clutch .................................................................................................................................................................. 24 Positions
Charger Input ...................................................................................................................................... 120 V, 60 Hz, AC only
Charge Rate .......................................................................................................................................................... 30 minutes
Torque ..................................................................................................................................................... Maximum 415 in.lb.
SPECIFICATIONS
UNPACKING
INSTRUCTIONS
When unpacking the tool:
■ Carefully remove the tool and accessories from the box.
■ Make sure that all items listed in the packing list are in-
cluded.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
1/2 in. (13 mm) Two Speed Drill
Charger
Battery Pack (2)
Auxiliary Handle
Double-ended Bit
Operator’s Manual
Case
WARNING:
If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
APPLICATIONS
You may use the two speed drill for the purposes listed below:
■ Drilling in wood
■ Drilling in ceramics, plastics, fiberglass, and laminates
■ Drilling in both hard and soft metals
■ Using driving accessories, such as driving screws with screwdriver bits
■ Mixing paints