Snorkel AB50J User Manual
Operator’s manual
Table of contents
Document Outline
- Table of Contents
- Electrical Hazard
- Introduction
- 1. Safety
- 2. Safety Devices
- Safety Device Information 2-1
- Alarms 2-1
- Other Safety Devices 2-3
- Battery 2-3
- Emergency Stop Switches 2-4
- At Ground Control Box 2-4
- At Platform Control Box 2-4
- Flashing Lights 2-4
- Foam Filled Tires 2-5
- Platform Foot Switch 2-5
- Lanyard Anchor Points 2-5
- Platform Guardrails 2-5
- Ground Fault Circuit Interrupt 2-6
- Platform Gravity Gate 2-6
- Ground Operation Switch 2-7
- Operator Horn 2-7
- Level Sensor 2-7
- Platform Swinging Gate 2-7
- Platform Work Lights 2-8
- Tipover Hazard Light 2-8
- 3. Specifications
- 4. Gauges
- 5. Automatic Shut-Offs and Circuit Breakers
- 6. Controls
- 7. Daily Inspection and Maintenance
- Daily Inspection and Maintenance Table 7-1
- Engine Fuel Level 7-2
- Fuel Tank Cap 7-2
- Engine Oil Level 7-2
- Fuel Leaks 7-3
- Engine Coolant Level 7-3
- Wiring Harnesses 7-4
- Battery Terminals 7-4
- Battery Fluid Level 7-5
- Hydraulic Oil Level 7-5
- Hydraulic Oil Leaks 7-5
- Tires 7-6
- Bolts and Fasteners 7-6
- Structural Damage and Welds 7-7
- Lanyard Anchor Points 7-8
- Platform Gravity Gate 7-8
- Swinging Gate 7-8
- Platform Guardrails 7-8
- Flashing Lights 7-9
- Air Filter 7-9
- Charging System 7-9
- Ground Control Switches and Alarms 7-9
- Level Sensor 7-10
- Emergency Power 7-10
- Platform Box Switches and Alarms 7-11
- Operator Horn 7-11
- Motion Warning Alarm 7-11
- Ground Fault Circuit Interrupt 7-11
- Platform Work Lights 7-12
- Slide Pads 7-12
- Axle Unlocked Alarm 7-13
- Placards and Decals 7-14
- 8. Operation
- 9. Emergency Operation
- 10. Stowing and Transporting
- 11. Options
- Chapter 12. Troubleshooting
- Index
- !
- A
- B
- C
- California Proposition 65 warning
- charging system, 7-9
- circuit breakers, 5-2
- cold weather start kit, 11-2
- controls
- control switches
- AC generator switch, 2-6
- AC Generator switch, 11-1
- anti-restart, 6-4, 8-5, 9-1
- battery switch, 6-6, 8-2, 8-4, 9-1
- boom speed, 6-2, 6-4, 8-2, 8-5, 9-1, 9-2
- choke/cold start, 6-2, 6-4, 8-3, 8-5
- drive range, 6-4, 8-5
- drive/steer controller, 6-4
- dual fuel, 6-4, 8-3, 8-5
- emergency power, 6-2, 6-4, 9-2
- emergency stop, 6-2, 6-4, 8-1, 8-4, 8-5, 9-1
- emergency Stop, 8-2
- extend/retract, 6-2, 6-4
- ground operation, 2-7, 6-2, 6-6, 7-9, 8-2, 8-6, 9-2
- horn, 6-4
- jib, 6-2, 6-4
- main boom lift, 6-2, 6-4
- master key switch, 2-1, 6-2, 7-1, 7-12, 8-3, 8-4, 9-1
- platform level, 6-2, 6-4
- platform rotate, 6-2, 6-4
- platform/ground selector, 6-2, 8-2, 8-4, 9-1
- riser lift, 6-2, 6-4
- swing, 6-2, 6-4
- drive/steer controller, 6-6, 8-6, 8-7
- ground control box, 6-2
- platform control box
- platform foot switch, 6-6
- control switches
- crushing hazard, 1-2
- D
- E
- electrical
- electrical (GFCI) outlets at platform, 8-8
- electrical hazard warning
- emergency operation, 9-1
- emergency power, 7-10
- engine
- air filter, 7-9
- alternator, 2-2
- automatic choke, 8-3
- coolant level, 5-1, 7-3
- coolant reservoir, 4-1
- engine oil dipstick, 4-2
- engine oil level, 7-2
- Ford - gasoline data, 3-2
- fuel gauge, 4-2
- fuel leaks, 7-3
- fuel level, 7-2
- Kubota diesel - data, 3-2
- LPG fuel operation, 8-4
- oil charts, 3-2
- oil filter, 5-2
- oil pressure, 5-1
- operating temperature range, 4-4
- engine shut-off alarm, 2-2
- extra battery, 11-2
- F
- G
- H
- I
- L
- M
- N
- O
- P
- Q
- R
- S
- safe operation, 1-1
- safety decals and placards, 1-3
- safety devices
- alarms, 2-1
- emergency stop switches, 2-4
- flashing lights, 2-4
- ground fault circuit interrupt, 2-6
- level sensor, 2-7
- operator horn, 2-7
- platform foot switch, 2-5
- platform gravity gate, 2-6
- platform guardrails, 2-5
- platform swinging gate, 2-7
- platform work lights, 2-8
- safety device information, 2-1
- tipover hazard light, 2-8
- safety precautions
- sandblast protection kit, 8-1, 11-2
- securing for day, 8-9
- serial numbers, 3-5
- signs, caution, danger, notes
- slide pads, 7-12
- spark arrestor, 11-3
- start up alarm, 2-1
- steering, 8-7
- stowing, 10-1
- structural damage and welds, 7-7
- T
- U
- W