Snorkel X52RT-sn10000+ - Manual (Page 32)

OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
27
To Extend and Retract Platform
1 Lift the platform extension lock handle to the
horizontal position.
2 Push the platform extension lock handle to
extend the platform to the desired position.
Do not stand on the platform extension
while trying to extend it.
3 Lower the platform extension lock handle.
Auxiliary Lowering
At the Ground Controls
In the event of a power failure, use the backup
auxiliary lowering function.
At the Platform Controls
Move the auxiliary lower switch down. Turn the
lift function enable button to lift function enable
and activate the up/down rocker switch in the
down direction.
Operation from Ground with
Controller
Maintain safe distances between operator,
machine and fixed objects.
Be aware of the direction the machine will travel
when using the controller.
Outrigger Operation (if equipped)
1 Position the machine below the desired
work area.
Note: The engine must be running for the
outriggers to operate.
2 Moe up and hold the auto level
switch.
3 Move the outrigger extend / retract switch in
the down direction. The outriggers will
extend and level the machine. A beep will
sound when the machine is level.
The indicator light on the lift function enable
button will turn red when one but not all
outriggers are down. All drive and lift functions
are disabled.
The light turns green on the lift function enable
button and on the individual outrigger buttons
when all the outriggers are in firm contact with
the ground.
The drive function is disabled while the
outriggers are down.
To control individual outriggers
1 Move the outrigger extend / retract switch
down to enable the extend function.
2 Move the left outrigger control switch up.
The LF outriggers will begin to extend.
Move the left outrigger control switch down.
The LR outriggers will begin to extend.
3 Move the outrigger extend / retract switch
up to enable the retract function.
4 Move the left outrigger control switch up.
The LF outriggers will begin to retract.
Move the left outrigger control switch up.
The LR outriggers will begin to retract.
5 Move the outrigger extend / retract switch
down to enable the extend function.
6 Move the right outrigger control switch up.