Snorkel PUSH 8 ECO8 - Manual (Page 9)

Page 8 of 25 Pop-Up PUSH 8 ECO Operator’s Safety and Maintenance Handbook ( rev.0.0.1.0210)
Section 3
SAFETY RULES
Safety Rules
NEVER Exceed the rated capacity (Safe Working Load or SWL) of the platform (240kgs).
NEVER Use the POP-UP PUSH 8 ECO as a ‘crane’ (e.g. by suspending loads from beneath the platform).
NEVER Make any attempt to increase the working height or outreach of the platform (e.g. by use of
stepladders in the platform).
NEVER Operate the POP-UP PUSH 8 ECO if the bubble spirit level is outside the marked limits.
NEVER Manoeuvre the POP-UP PUSH 8 ECO on an inclined surface otherwise it may become
uncontrollable.
NEVER Manoeuvre the POP-UP PUSH 8 ECO whilst in its elevated position, as this may cause instability.
NEVER Manoeuvre the POP-UP PUSH 8 ECO with a person or materials in the platform.
NEVER Enter or exit the platform unless the platform is in the lowered and transport position.
NEVER Apply external side loads to the platform or scissor structure.
NEVER Allow persons at ground level to operate the controls whilst the platform is occupied (unless in an
emergency situation).
NEVER Operate the POP-UP PUSH 8 ECO outdoors.
NEVER Attempt to overreach.
NEVER Interfere with, wedge or attempt to override hydraulic, electrical or mechanical safety devices.
ALWAYS Check that there are no obstructions or persons that may be struck by the platform before and
during the raising and lowering of the platform.
ALWAYS Ensure that the access gate is closed once the operator has entered the work platform.
ALWAYS Ensure that another responsible person on site knows how to use the emergency controls.
ALWAYS Undertake the daily checks recommended in this handbook prior to operation of the machine.
ALWAYS Ensure that all instructions, warning and Safe Working Load decals are clean and legible.
ALWAYS Ensure the POP-UP PUSH 8 ECO is positioned on adequate ground to support the weight of the
machine.
ALWAYS Ensure that sufficient clearance is given if working near to live conductors.
ALWAYS Ensure the manual rear brakes have been engaged before elevating the work platform.
ALWAYS Ensure that auto front brakes are functioning correctly before attempting to use the machine.
ALWAYS Ensure that the platform does not come into contact with fixed objects (e.g. buildings, etc.) or
moving objects (e.g. vehicles, other plant equipment, etc.).
ALWAYS Replace any removable guard rails (e.g. close and lock access gate) to enable full edge protection
to be maintained.
ALWAYS Ensure that the load is evenly distributed within the platform.
ALWAYS Ensure the safety of persons that may enter the area around the platform (e.g. cordon off the area
to prevent persons entering the danger area).
ALWAYS Ensure hands are kept within the confines of the guard rails whilst elevating the work platform.