Snorkel M2639J-sn1000+ User Manual
Page 19

2 - 9
2. Operation & Specifications
Figure 4: Lower Control Panel
T
YPICAL
O
PERATION
Raising the mast.
• The Keyswitch must be turned to lower controls (2).
• Select Mast using the selector switch (4)
• Press up and hold the switch (5),
• Activate the Rocker Switch (2) in the direction required.
E
LEVATING
& L
OWERING THE
W
ORK
P
LATFORM
Before operating the MB20N Work Platform it is imperative that the pre-operation Safety
Inspection has been completed and any deficiencies have been corrected. The
operator must also be fully trained in the use of this machine.
Before beginning any operation, the following checks should be carried out.
NOTE: Chassis controls are for service use only.
W A R N I N G
!
!
ENSURE that no other persons are within 1 metre of the machine.
Be aware of the pothole protection bar hazard on both sides of the
machine.
LOOK up and around for obstructions before performing the lift or
drive functions.
DO NOT overload the platform.
DO NOT operate near electrical power cables, keep within national
safety limits.
THIS WORK PLATFORM IS NOT ELECTRICALLY INSULATED.
3
4
1
6
5
1. Emergency Stop
2. KeySwitch - Platform Controls
3. Analogue Rocker
4. Selector Switch - Jib
5. Enable Switch
6. Hour Meter/Battery Capacity Indicator
- OFF
- Lower Controls
- Mast
- Mast Rotate
2