Bunn Axiom Series - Manual (Page 7)

Page 7
OPERATING CONTROLS
(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator
on) supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refi ll circuit. Pressing the
switch again (indicator off) stops tank refi lling and brewing
and de-energizes the brew station warmer. Stopping a brew
cycle after it has been started will not stop the fl ow of water
into the server until the funnel is empty.
NOTE – Hot water will be available at the faucet in a limited
amount when the "ENABLE BREW ON/OFF" switch is in
the "OFF" position because the tank will not refi ll.
(B) BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ENABLE BREW
ON/OFF" indicator is on.
(C) ADDITIONAL WARMER SWITCHES
Pressing any additional warmer switch so that the indicator is on, supplies power to the associ-
ated warmer.
P3633
39130 060206
COFFEE BREWING
1. Begin each brew cycle with a clean empty brew funnel.
2. Insert a BUNN fi lter into the funnel.
3. Pour (or grind) fresh coffee into the fi lter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator is on.
7. Momentarily press and release the "BREW" switch. There may be certain situations in which the
brew cycle will not begin when the "BREW" switch is pressed:
a. "SWITCH NOT ON" - The "ENABLE BREW ON/OFF" indicator must be on.
b. "BREW TEMPERATURE TOO LOW" – wait until heated, or disable "BREW LOCKOUT".
8. If none of the above messages are displayed, the display will read "NOW BREWING", and show
the time remaining in the brew cycle.
9. Following the brew, the display reads "DRIPPING" which shows the time remaining until the cof-
fee no longer drips from the funnel tip.
10. After the coffee fi nishes dripping from the funnel tip, carefully remove the brew funnel and discard
the grounds and fi lter.
B A C