Road Armor 2015 Chevy 2500 Rear Bumper - Manual (Page 3)

This picture is shown upside down.
The final steps to installing your RA bumper would be the following:
1. Mount RA bumper to the brackets loosely.
2. Align bumper left, right, up and down then making sure the tailgate does not hit.
3. Tighten down all hardware and install remaining bolts.
4. Install sensors back into bumper
5. Install receiver plug plate on backside of the bumper clip in the plug, tighten hardware
6. Finally install the RA badges
Install one bolt plate with retainer clip on each side of the RA bumper.
Receiver
plug plate
RA Badges
Enjoy your new Road Armor bumper