MBW EXA30 - Manual (Page 7)

- 4 -
O
PERATION
Introduction
MBW equipment is intended for use in very severe
applications. They are powered by four cycle engines and
are available in different sizes and a selection of engines.
This parts manual contains only standard parts. Variations
of these parts as well as other special parts are not included.
Contact your local MBW distributor for assistance in
identifying parts not included in this manual.
Before Starting & Operating
• REMEMBER! It is the owner’s responsibility to
communicate information on the safe use and proper
operation of this unit to the operators.
• Review ALL of the Safety Precautions listed on page 1 of
this manual.
• Familiarize yourself with the operation of the machine
and confirm that all controls function properly.
• Know how to STOP the machine in case of an
emergency.
• Make sure hands, feet, and clothing are at a safe
distance from any moving parts.
• OIL LEVEL - Check the oil level in the engine. For more
information see “Lubrication” under the respective
engine’s “Owners Manual” or the Maintenance section of
this manual.
• AIR CLEANER - Check to ensure element is in good
condition and properly installed.
• FUEL SUPPLY - The engines on MBW equipment
require an automotive grade of clean, fresh, unleaded
gasoline.
• FUEL FILTER - If clogged or damaged, replace.
Operating
1. Do not run exciter when roller attachment is not in
contact with the ground.
2. The EXA attachments are not recommended for
excavators exceeding 45,000 lbs. (18,000 lbs for
EXAL18)
3. See Specifications, page 3, for hydraulic
requirements
4. Do not apply excessive down force when compacting
soil.
5. Ensure host machine has adequate lifting capacity to
handle the weight of the roller. Refer to
Specifications, page 3. for attachment weights.
CAUTION
Back pressure in return line must not exceed 200
PSI. Excessive back pressure can damage hy-
draulic motor.
WARNING
Always stop the engine before:
Adding fuel.
Leaving the equipment unattended for any
amount of time.
Before making any repairs or adjustments to the
machine.