BenQ Professional VP150X - Manual (Page 14)

10
English
The remote control allows you to operate the function keys on the projector and to emulate mouse function when the
projector is connected to a computer.
Inserting Batteries in the Remote Control
Be sure to follow instructions in placing batteries into the remote control units.
z
Push and slide the lid in the direction of the arrow.
z Install two ‘AAA’ batteries as indicated inside the battery compartment.
z Replace the lid and snap into place.
Figure 15.
Battery replacement process
Main Unit Function
Standby/On To turn the projection lamp on and off.
Freeze Pressing this button displays a still (frozen) picture.
Magnify Pressing this button partially magnifies a displayed picture.
(Move the picture with the Disk Pad after pressing the Magnify button.)
Disk Pad When the OSD menu is active, Disk Pad acts as selecting device. When the
on-screen menus are not active, it works as mouse pad. When the magnify function is
active, use disk pad to move through the picture.
Menu Call the OSD Menu.
Blank The blank screen is displayed by pressing Blank. And the blank screen will be revealed
partially from top to bottom by pressing Blank again.
Source Selects the input source.
Return Image ration backs to 1:1.
Volume Adjusts volume. The sound gets louder or quieter by pressing the "+" or "-" button.
Laser Laser pointer on button. Use as a stick (for indication).
Mouse Left-Click When operating in mouse emulation mode, it registers a left mouse click.
Mouse Right-Click When operating in mouse emulation mode, it registers a right mouse click.
Exit To leave current OSD Pages.
i-key To adjust position, phase automatically.
Caution
z
Avoid excessive heat and humidity.
z
Do not mix new and old or different types of batteries.