Apple TV (1st generation) User Manual
Page 31
Chapter 4
Problem? No problem.
31
 If you paired an Apple Remote with Apple TV, make sure you’re using the paired
remote. See “Pairing Apple TV with a Remote” on page 23.
 Reset Apple TV by unplugging it from the power outlet, waiting about five seconds,
and plugging it in again. You can also press and hold both » and D on the Apple
Remote for about 6 seconds to reset Apple TV. Your movies and other content will
remain on Apple TV.
If Apple TV still doesn’t respond, try restoring it to the original factory settings
 Press and hold both » and D on the Apple Remote for 6 seconds or until the status
light blinks amber.
 Choose a language.
 Choose Factory Restore.
During a factory restore, the progress indicator (a spinning gear) may spin for a while,
so be patient.
 If your network doesn’t use DHCP, choose Configure TCP/IP and enter the TCP/IP
configuration.
 If you still don’t see Apple TV in the Source list in iTunes, go to the Apple TV Support
page for more information:
www.apple.com/support/appletv
If you can’t hear sound
 If Apple TV is connected to an A/V receiver, make sure the receiver is turned on.
 Make sure the input setting you’ve selected on your receiver matches the input you
have your audio cables connected to. See the documentation that came with your
receiver for more information.