Blaupunkt NASHVILLE DAB47 - Manual (Page 8)

64
Notes:
All the current settings are saved.
Any CD already inserted in the device
remains there.
The device switches off automatically
after approx. one minute.
Attaching the control panel
Hold the control panel at approximately
right angles to the device.
Slide the control panel into the device’s
guides that are positioned on the left
and right at the lower edge of the hous-
ing. Push the control panel carefully into
the bracket until it clicks into place.
Flip up the control panel and carefully
press it into the device until it clicks into
place.
1.
2.
Note:
When attaching the control panel, make
sure you do not press the display.
If the device was still switched on when you
detached the control panel, it will automati-
cally switch on with the last setting activat-
ed (radio, CD/MP3, SD/MMC, CD changer
or AUX) when the panel is replaced.
•
•
•
u
u
u
Switching on/off
There are various ways of switching the de-
vice on/off:
Switching on/off using the vehicle
ignition
The device will switch on/off simultaneous-
ly with the ignition if the device is correctly
connected to the vehicle’s ignition and you
did not switch the device off by pressing
button
1.
Switching the device on/off using the
detachable control panel
Detach the control panel.
The device switches off automatically after
approx. one minute.
Attach the control panel again.
The device switches on. The last setting
(radio, CD/MP3, SD/MMC, CD changer or
AUX) will be reactivated.
Switching on/off using button
1
To switch on the device, press button
1.
To switch off the device, press and
hold down button
1 for longer than
two seconds.
The device switches off.
Note:
To protect the vehicle battery, the de-
vice will switch off automatically after
one hour if the ignition is off.
u
u
u
u
Control panel Switching on/off
02_NashvilleDAB47_gb.indd 64 02_NashvilleDAB47_gb.indd 64 20.07.2007 11:48:18 Uhr 20.07.2007 11:48:18 Uhr