Caution, Service and repair – Bosch WTMC6521UC User Manual

Page 24

Degree of drying has not been reached
or the drying time is too long.
Display may indicate E:03".

Moisture sensor dirty.

Clean moisture sensor as described on page 22.
Switch off/switch on again.

or the drying time is too long.
Display may indicate E:03".

Exhaust air duct is blocked or too long.

Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 8.
Switch off/switch on again.

Lint filter dirty.

Clean filter as described on page 22.
Switch off/switch on again.

Laundry was too wet.

Spin laundry at higher speed in the washing
machine. Switch off/switch on again.

Unsuitable program selected.

Select program with aid of the program selection
table (see page 18). Switch off/switch on again.

Maximum drying time was exceeded.

Clean lint filter (see page 22).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.

Motor limit temperature was exceeded.

Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.

Degree of dryness not correct set.

Change settings for degree of dryness, see page 15

Lint filter LED is blinking after lint filter
has been cleaned

Blinking of lint filter LED is not an indication of a
problem. It is used only as a reminder.

No action required. Light will stop blinking.

SERVICE and REPAIR

CAUTION

CAUTION - Label all wires prior

to disconnection when servicing

controls. Wiring errors can cause

improper and dangerous

operation. verify proper

operation after servicing.

The Bosch dryers require no special

care other than the care and cleaning

noted above.

If you are having a problem with

your dryer, before calling for

service please refer to Table on

page 23, following.

If service becomes necessary, contact

your dealer or installer or an authorized

service center. Do not attempt to repair

the appliance yourself. Any work

performed by unauthorized personnel

may void the warranty.

If you are having a problem with your

Bosch dryer and are not pleased with

the service you have received:
-

First, please contact your installer

or the Bosch Authorized Service

Contractor in your area and

explain to them why you are not

satisfied. This will usually correct

the problem.

If after working with your installer

or service person the problem still

has not been resolved to your

satisfaction, please let us know by

either writing to us at,
BSH Home Appliances

5551 McFadden Avenue

Huntington Beach, CA 92649

or, calling us at

1Ć800Ć944Ć2904.

Please be sure to include, if writing, or

have available, if calling, the following

information:
-

Model Number

Serial Number

Date of Original Purchase

Date Problem Originated

Explanation of Problem

Also, if writing, please be sure to

include a daytime telephone number

and a copy of the sales invoice.
You will find the model number and

serial number information on the rating

plate located on the inside of the front

panel.