Bosch WTMC6521UC - Manual (Page 23)

23
q Loosen the screw of the cover and
open the cover.
q Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
q Replace the cover and secure with
the screw.
q Plug in dryer or reconnect power
supply.
Troubleshooting
d WARNING d
TO AVOID RISK OF ELECTRICAL
SHOCK !
TO AVOID EXPLOSION HAZARD!
Repairs or replacement of parts may
be carried out by authorized
technicians only.
Before calling the customer service,
check whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
1. Set program selector to Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Close the shutĆoff valve.
5. Call customer service
(see page 24).
Problem Possible cause Remedial action
Dryer does not start. Main plug not inserted at all or not inserted correctly. Insert main plug correctly. Dryer does not start.
Start/Stop" indicator light does not A fuse of power supply has tripped. Replace/switch on fuse. Start/Stop" indicator light does not
illuminate.
Start/Stop" button not pressed. Press Start/Stop" button. illuminate.
No program selected. Select program.
Door not closed. Close door.
In TimeĆPrograms duration not chosen. Chose time via Select"ĆButton.
Ambient temperature below 41 ° F/5 ° C. Increase room temperature.
Laundry is wet after drying. The shutĆoff valve is closed. Open the shutĆoff valve.
Program has been interrupted.
A warning signal is emitted and the
display shows E:01". Lint filter dirty. Clean filter as described on page 22.
Switch off/switch on again.
A warning signal is emitted and the
display shows E:01".
Exhaust air duct is blocked or too long. Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 8.
Switch off/switch on again.
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
The room/cabinet is not adequately ventilated. Provide an adequate supply of fresh air.
Switch off/switch on again.
Drum light does not function. No program selected. Select program. Drum light does not function.
Light bulb defective, light bulb burned out. Change light bulb, see page 22.
No power supply. Guarantee power supply.
Light bulb is loose. Tighten light bulb. Remove and reinstall the cover as
directed on page 22.
Start/Stop" indicator light does not
illuminate.Wrinkle block" indicator
lights.
The display shows 000". Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.