Hornady Lock-N-Load Auto Charge - Manual (Page 4)

4
WARRANTY
The Hornady Lock-N-Load ® Auto Charge
™
is a highly sensitive instrument, which
must be repaired and serviced by a factory qualified technician to maintain the
warranty.
Hornady Manufacturing warrants to you that for one year from the date of
purchase, your Lock-N-Load
® Auto Charge
™
will be free from defects in material
and workmanship. This warranty does not cover damage caused by normal wear,
accidents, abuse, or failure to provide proper care and maintenance. Please contact
Hornady Manufacturing at 1-800-338-3220 for service or warranty information.
The warranty is void if the seal on bottom of unit has been tampered with.
C. QUICK START
1) Verify unit is properly assembled with the scale plate, powder pan, and the
clear powder tube in place.
2) Turn unit on by plugging in and pressing ON/OFF button. For best performance,
allow to stabilize for 5-15 minutes before use.
3) Calibration is recommended before each use (see Section E).
4) Ensure the powder pan is on the scale, and that the actual weight reading
(right side of display) reads “ 0.0 “. If not, touch the ZERO button.
5) Verify the powder reservoir empty tube cap (at rear, right side) is closed. Fill
the clear powder tube to at least a level just visible at the bottom of the clear
tube. Fill higher if loading many rounds.
6) Enter Target Weight using the numerical key pad. The last number you enter
will be the decimal amount of your charge: xx. X . Press ENTER to store Target
Weight.
7) Press DISPENSE to begin dispensing powder charge you have entered.
8) Press and hold the TRICKLE button to increase the charge weight.
9) Should the dispensed charge be greater than 0.1 grains above your targeted
amount, “ OVER” will be displayed. Press ENTER to remove the “OVER” warning.
You can either dump the charge into the powder tube and re-dispense, or
remove only a small amount of the powder, and use the
TRICKLE button to
bring to desired weight.