PureFlow AirDog RP-150 - GM 1992-2000 - Manual (Page 12)

12
Raptor™ 100 & 150 1992 – 2000 Chevy Diesel
Section 5B Fuel Lines
Installing the
Fuel Supply Line from the fuel tank to the Raptor

5B-1. Cut the steel fuel line that goes to the engine and install a 3/8”
compression fitting with a 3/8” NPT female x-8 JIC on the end of
that line.
Figure 13
5B-2. Insert the female quick connect end (see figure 14) of the “Suction Hose Assembly” to
the male fitting installed in the fuel “IN” port during step 4-1 of this manual. A “click”
will be heard when the fitting is properly connected.
Figure 14
5B-3. Measure and cut the length of the “Suction Hose Assembly” necessary to reach the fitting
on the end line referenced in step 5B-1.
5B-4. Install a straight -8 swivel x 1/2" Push Lock fitting on each end of that fuel line.
Lubricate the barb end of
Push the fuel line completely
the Push Lock fitting with oil. onto the barb end of the fitting.
Figure 15 Figure 16
5B-5. Connect the fuel line to the respective fittings on the Raptor and the fuel line from the
tank.
Figure 17 Figure 18