PureFlow AirDog RP-150 - GM 1992-2000 - Manual (Page 10)

10
Raptor™ 100 & 150 1992 – 2000 Chevy Diesel
Section 5A Fuel Lines
Installing the Raptor™ Fuel Supply Line to the Engine
5A-1. Remove the factory electric fuel Pump
mounted on the driver’s side frame rail.
Figure 6
NOTE: Assemble the compression
fitting to the -8 JIC flare fitting.
5A-2. Cut the steel fuel line that goes to the engine and install a
3/8” compression fitting with a 3/8” NPT female x -8 JIC
on the end of that line.
Figure 7
5A-3 Insert the female quick connect end (see figure 8)
of the “Pressure Hose Assembly” into the male quick
connect fitting previously installed in the port marked “OUT”.
You will hear a “click” when it connects.
Figure 8
5A-4. Measure and cut the length of the “Pressure Hose Assembly” necessary to reach the
fitting on the end line referenced in step 5A-2.
Figure 9 Figure 10