PureFlow AirDog RP-150 - Dodge Cummins 1994-1998 - Manual (Page 14)

14
PureFlow AirDog
Raptor
™ 100 & 150
1994 - 1998 Dodge Cummins
Section 6 Electrical Harness
WIRING DIAGRAM
Figure 20
Installing the Raptor™ Fuel Pump wiring harness.
6-1. Connect the Power Supply Lead to the Raptor™, by inserting the 2 pin Deutsch
connector on the end of the wiring harness into the corresponding connector on the
Raptor™.
Figure 21
6-2.
Crimp the male spade connector on the end of the Red (+) wire.
Ground Wire
Hot Lead
Water Proof Fuse
Raptor Pump Lead
Figure 22 Figure 23 Figure 24
6-3. To connect to the power lead to the fuse panel, route the Red (+) wire to the fuse panel
located under the hood on the driver’s side wheel house and insert the male spade
connector into a spare fuse holder on the panel that is “hot” when the starter key is turned
to the on position.
6-4. Connect the Green (-) wire to an adequate ground.
BE SURE TO PROPERLY ROUTE AND SECURE THE WIRING HARNESS TO THE
VEHICLE.