PureFlow AirDog DF-200 - Dodge Cummins 1994-1998 - Manual (Page 22)

22
AirDog®
WATER
SEPARATOR
PureFlow AirDog
AirDog®II DF-200 Dodge Cummins 1994 - 1998
Section 8 Fuel Filter & Pre-filter
Filter Service Recommendations
Plugging of either the fuel filter or the water separator itself will cause low fuel pressure
and low flow to the engine. If a low fuel pressure issue exists, replace the fuel filter.
AirDog®
2 Micron Fuel Filter
Drain Valve
The Water Separator
Replace the water separator every other time you change the Fuel Filter or if it becomes
damaged or plugged. It is suggested to check/drain the water separator every three
months or as needed should you experience excessive ‘water in fuel’ conditions. When
installing the water separator, be sure to clean the underside of the AirDog
®
base.
Follow the instructions printed on the pre-filter for proper tightening procedures.
CAUTION: Be extremely careful to prevent any contaminates or debris from entering the
pre-filter when removing it for cleaning! Large debris will jam the Gerotor and cause the fuse
to blow. This is not a warranty item. Should this happen, you can easily put the system back
into working order. See the instructions on “How to clean the Gerotor” for proper
procedures
.
The Fuel Filter
Remove the fuel filter by turning it counter clockwise. Do Not pre-fill the fuel filter with
fuel. The AirDog
®
will fill the filter and prime the system automatically. Follow the
instructions on the filter for proper tightening procedures.
CAUTION: Dispose of waste fuel and used filters properly to protect OUR environment!