PureFlow AirDog DF-200 - Dodge Cummins 1994-1998 - Manual (Page 11)

11
PureFlow AirDog
AirDog
®
II Dodge Cummins 1994 - 1998
Section 5-A Fuel to Engine
Installing the Fuel Supply Line from the AirDog
®
II to the P-7100!
The AirDog
®
II fuel filter is 2 micron media. When installing the AirDog
®
II fuel system
it is recommended to bypass the factory filter canister.
5A-1. Remove the 14mm banjo bolt and original factory fuel supply line at the fuel inlet
port of the P-7100 injector pump and from the original fuel filter head outlet port.
P-7100 Fuel Inlet Port
Figure 14 Figure 15 Figure 16
5A-2. Install the 14mm x ½” male SAE J2044 (WAP 103) fitting with the seal washer
supplied into the inlet port of the P-7100 (Ref. Figure 17) vacated by the original
banjo fitting. Do not over tighten the fitting. It may break.
Figure 17
5A-3 Insert the female quick connect end (see figure 18) of the
“Pressure Hose Assembly” into the male quick connect fitting
previously installed in the port marked “ENGINE”. You will hear
a “click” when it connects.
Figure 18
5A-4. Connect the other end of the “Pressure Hose Assembly” to
the inlet fitting installed in step 5A-2. It too will “click” when properly connected.
5A-5 Any excess fuel hose can be addressed by routing the house in a fashion to take up
the extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.
NOTE: It is not necessary to keep the factory filter canister in the system