PureFlow AirDog DF-200 - Dodge Cummins 1994-1998 - Manual (Page 19)

19
PureFlow AirDog
AirDog®II DF-200 Dodge Cummins 1994 - 1998
Section 6 Electrical Harness
Connecting the AirDog
®
II Relay Control to the Fuse Panel
6-2. Route the red, Relay Trigger, wire with the mini fuse
tap attached to the fuse panel located under the hood
on the driver’s side. Insert the mini fuse tap into a spare
fuse holder on the panel that is “hot” when the starter
key is turned to the on position.
Figure 48
6-3.
Route the pump motor lead to the AirDog
®
II
Connect the 2 pin Deutsch connector on the end of the
wiring harness into the corresponding pump motor lead
connector on the AirDog
®
II.
Figure 49
NOTE: The power supply leads can be connected to the battery or the alternator.
Connecting the power supply leads to the alternator instead of the battery
will create a corrosion free connection.
Black (-) Red (+) Replace the Protective Cover
Figure 50 Figure 51
6-4A. Route the Red & Black power supply leads to the alternator Connect the Black (-)
lead to the alternator Chassis Ground connection. Connect the Red (+) lead to the
alternator Hot Lead going to the battery.