Fast & Fluid X-Smart - Manual (Page 7)

Safety X-Smart V 1.2
7
2 Safety
2.1 Intended use
The machine is designed to dispense colorants into a can. Any other use of the machine is strictly forbidden.
2.2 Liability
Our machines and accessories are fully compliant with the CE regulations. Any modification can result in not
fulfilling the CE safety requirements and is therefore not allowed. Fast & Fluid Management B.V. will not accept
any responsibility in case of modifications to machines and/or accessories.
Fast & Fluid Management B.V. is not liable if you do not follow the rules below:
-
The machine is for indoors use only.
- This machine may only be used for commercial settings. The machine is not a household appliance.
- Do not use a damaged machine. When you have doubts, contact your supplier. See § 5.1.
- Install and connect the machine according to the instructions on the installation instructions sheets.
- Observe all local safety regulations.
- Place the machine in a well-lit and well-ventilated room.
- Make sure that the load capacity of the floor meets the minimal requirements. Refer to § 6.2.
- Connect the machine to a grounded wall socket.
- Do not use extension cords.
- Make sure that the machine is installed as prescribed in the installation instruction sheets.
- Keep the machine in good condition. Make sure that defective parts are immediately replaced.
- Replace parts only with original Fast & Fluid Management B.V. spare parts.
All maintenance beyond the scope of this manual must be carried out by a qualified service technician that Fast
& Fluid Management B.V. has trained and certified.
2.3 User qualification for installation
Only install the machine if you have written permission from the supplier of the machine.
WARNING
Read the manual before you install or use the machine. Failure to do so can result in personal
injury, death or property damage.
WARNING
Do not place objects on top of the machine.