L.B. White 100 Tradesman Portable Forced Air - Manual (Page 9)

GAS HOSE REGULATOR
REGULATOR VENT
TO LP-GAS CYLINDER
GAS FLOW
TO HEATER INLET
1. Fasten the carrying handle to the heater case top
using the four (4) sheet metal screws provided. See
Fig.1.
2. The handle may also be fastened to the side of the
case top for stacking during storage. Do not stack
more than two high.
FIG. 1
1. Always use approved pipe thread compound suitable
for use with propane gas on the threaded
connections.
2. Assemble the components together as shown in
Fig.2. This view is to show general assembly of the
components only. The regulator must always be
installed so its vent is always pointed downward when
attached to the propane gas supply.
3. Tighten all connections securely.
4. Check all connections for gas leaks using approved
gas leak detectors.
FIG. 2
HOSE AND REGULATOR ASSEMBLY
CARRYING HANDLE ASSEMBLY
ALTERNATE
HANDLE LOCATION
HANDLE
SCREW
8