AKiTiO Taurus Super-S LCM - Manual (Page 7)

Taurus Super-S LCM System Setup
[5]
4. Install the second hard drive and mount it with two screws on each side.
5. Connect the SATA and power cables to your hard drives. Be careful not to damage any
components and confirm that the cables are connected firmly.
6. Slide the inner chassis back into the outer enclosure and fasten the four screws to finish the
assembly.
7. After turning on the power and connecting it to the computer use the disk management tool
(PC) or disk utility (Mac) to create a new partition and format the drives. If you have
selected the option to set the RAID mode via LCD display, set the RAID mode first, before
you format the drives.
8. Done! Your drive is now ready to use.
Note
This device is designed for two hard drives and does not work when only one HDD is installed.
Important
Upon initial start up of the device and when changing the RAID mode, any existing data on the
installed hard drives will be erased. Please make sure you backup all data prior to installing
the hard drives and prior to changing the RAID mode!