Steele Products SP-GG350 - Manual (Page 17)

Installation
Note: Prior to powering tools and equipment, make sure the
generator’s rated voltage, wattage, and amperage capacity
(two120V-25AMPs outlets/one 240V-12.5AMPs outlet) is adequate
to supply all electrical loads that the unit will power. If powering
exceeds the generator’s capacity, it may be necessary to group
one or more of the tools and/or equipment for connection to a
separate generator.
Electrical and other permits may be required for the installation of
emergency power systems. Investigate your local building and electrical
codes before installing this unit. Installation must be completed by licensed
contractors.
WARNING! THE GENERATOR WEIGHS APPROXIMATELY 107
POUNDS. USE CARE AND THE PROPER LIFTING OR HOISTING
EQUIPMENT WHEN MOVING IT TO THE INSTALLATION LOCATION.
ALWAYS CONNECT HOIST LINES TO THE FRAME OF THE
GENERATOR.
General Location
Make sure to locate and install the generator outdoors where cooling air
is readily available.
Install the generator so that the air inlets and outlets are not blocked by
obstructions such as bushes, trees, or snow drifts. Locating it in the path
of heavy winds or snowdrifts may require the placement of a barrier for
protection. In normal weather conditions, the air vent should face the
prevailing wind direction.
Install the generator on a concrete slab or other area where rain
drainage or flood waters can not reach it.
Generator placement should allow four feet of access to all sides for
maintenance.
Place the generator as close as possible to the electrical tools and
equipment being powered to reduce the length of extension cords.
If the generator in located indoors the engine exhaust must be ventilated
to the outdoors using leak-proof, heat resistant flexible metal, flex
tubing.
16
3.5KW Generator