Steele Products SP-PT135 - Manual (Page 5)

9
Battery Charger & Plug (cont’d)
Inserting the battery
Insert the battery pack into the tool handle.
Charging the battery
The battery supplied with this power tool contains a
test charge only and must be fully charged before use.
Be sure to read all safety instructions before charging
the battery.
The battery will become warm during charging. This
is normal.
1 Plug the charger into a standard 110-120V~60Hz
outlet, being sure not to knot or kink the cord.
2 The battery has a keyway to ensure proper
alignment. Insert the battery into the charger unit.
3 Time the charge for 3-5 hours only.
4 Unplug the charger when not in use and store it in a suitable storage cabinet.
Note: Avoid charging your battery in freezing conditions as charging
power will not be sufficient.
CAUTION: WHEN CHARGING MORE THAN ONE BATTERY PACK
IN SUCCESSION, ALLOW AT LEAST 30 MINUTES FOR THE
CHARGER TO COOL DOWN BEFORE CHARGING THE
ADDITIONAL BATTERY.
WARNING! ALWAYS REMOVE THE BATTERY PACK AND
STORE IT SAFELY WHEN THE TOOL IS NOT IN USE.
19.2V Cordless Drill Owner’s Manual
10
Battery Charger & Plug (cont’d)
Additional or replacement batteries
Additional or replacement batteries specifically designed to work with this tool and
charger are available from your service center. (888-896-6881)
Discharging the battery
Use the tool until it loses all effective power before recharging the battery.
Recharging partially used batteries may eventually cause a memory effect that will
prevent batteries from accepting their full capacity. Making sure to charge batteries
completely before use and discharge them completely before recharging will help
them preserve their full capacity.