Steele Products SP-PT135 - Manual (Page 4)

Owner’s Manual
7
Additional Warnings
Battery Charger
This 120V~60Hz charger is double insulated and therefore does not require a
grounding connection. It is a sealed unit fitted with an internal fuse which
cannot be replaced.
There are no user serviceable parts inside this charger. Never remove any part
of the casing unless qualified to do so. If in doubt, consult a qualified
electrician.
For your protection, do not expose this charger to rain or use in damp locations.
Do not place the charger on damp or wet surfaces; use a workbench if available.
For added protection use a suitable Residual Current Device (RCD) at the wall
outlet.
This charger unit is intended for use with this specific tool only and must not be
used for any other use. Do not use any other charger for charging these
batteries.
Never exceed the charging time specified in the manual as this could damage
both the battery and the charger.
WARNING! THIS CHARGER AND BATTERY PACK ARE
SPECIFICALLY DESIGNED TO WORK TOGETHER. DO NOT
ATTEMPT TO CHARGE ANY OTHER BRAND OF CORDLESS
TOOL OR BATTERY PACK WITH THIS CHARGER.
WARNING! THIS UNIT CONTAINS DANGEROUS VOLTAGES.
WARNING! NEVER USE THE CHARGER IN YOUR HOME,
ALWAYS CHARGE BATTERIES ON A BENCH IN YOUR
WORKSHOP.
8
Additional Warnings (cont’d)
Battery Charger (cont’d)
When the battery fails to charge or maintain its charge, its usable life is
exhausted. The battery should be disposed of in an environmentally friendly
manner. Do not dispose of the battery in the household disposal system. Take
the battery to a recycling or specialized center for disposal.
Drill
Keep drills, drivers and other cutters sharp and in good condition to improve
cutting and ensure tool and accessory life.
Use only manufacturer-recommended bits, drivers, and cutters.
Do not attempt to modify the tool or its accessories in any way.
Do not force the tool. Let it do the work, This reduces wear and increases
efficiency and operating life.
Use approved safety glasses or goggles, face mask, and ear protection.
When using the tool above your head height, wear an approved safety helmet,
safety glasses or goggles, and an approved face mask.
Beware of high torque when drilling, especially when drilling masonry.
When drilling masonry, do not force the drill. Let the drill and hammer action
do the work
Do not change any selector switches while the motor is running.
Always remove the battery pack when the drill is not being used.
Do not carry the drill with your finger on the trigger. Always turn the rotation
lever to neutral to prevent accidental starting.
WARNING! DO NOT DISPOSE OF THE BATTERY BY
INCINERATION AS THE BATTERY WILL EXPLODE.
19.2V Cordless Drill