Steele Products SP-PT135 - Manual (Page 3)

Owner’s Manual
5
General Precautions (cont’d)
Where there is a risk of heavy objects damaging feet or if there is a risk of
slipping on wet or slippery floors, suitable non-slip safety footwear should be
worn.
Where there is a risk of falling objects or hitting your head on protruding or low
level obstructions, a hard hat should be worn.
Be sure you always have sure footing, especially when working on ladders and
scaffolding.
Keep electric tools away from humidity and rain. Do not immerse.
When working outdoors, only use tools and extension cables designed and
approved for outdoor use.
Do not use the equipment in any areas any danger of fire or explosion exists.
Keep batteries away from heat and allow to cool if warm.
If the tool requires repair, be sure to have all work performed by a qualified
technician.
Keep all electric tools away from children.
Store electric tools in the original box in a clean dry location out of the reach of
children.
Always unplug the power cable when the tool is not in use or when you are
taking breaks or changing accessories.
Never carry the tool by the cable. Never unplug the tool by pulling on the cable.
When working, do not allow the motor to stall under the load.
Keep your work place tidy. Untidiness can cause accidents!
Avoid abnormal body postures while working.
Make sure not to start the tool unintentionally.
Do not leave keys, spanners, adjusting tools, etc. inserted in the tool.
WARNING! CONSUMING ALCOHOL, MEDICATION, OR
DRUGS, OR HEALTH PROBLEMS SUCH AS ILLNESS,
FEVER, OR FATIGUE, AFFECT YOUR ABILITY TO PLAN
AND REACT. NEVER USE ANY ELECTRICAL EQUIPMENT
WHILE UNDER THE INFLUENCE OF ALCOHOL, DRUGS,
HEALTH PROBLEMS, OR FATIGUE.
6
General Precautions (cont’d)
Keep cutting tools sharp and clean.
Follow all instructions for lubrication and changing accessories.
Before using the power tool, check it carefully to ensure that it will operate
properly and perform its intended function.
Check that all moving parts are correctly aligned and free from binding.
Check for broken or missing parts and have them replaced or repaired at an
authorized service center.
If the power tool requires mounting make sure it is securely attached to a
suitable work bench.
Check any other condition that may affect the operation of the power tool.
Any damaged guard or any other damaged part of the power tool should be
properly repaired or replaced by an authorized service center unless otherwise
indicated in this instruction manual.
Any switch that does not operate correctly must be replaced by an authorized
service center. Do not use the power tool if the ON/OFF switch does not turn
the power tool ON and OFF.
Do not attempt to modify the power tool in any way. The use of any attachment
or accessory other than those recommended in this instruction manual could
result in damage to the power tool and injury to the operator.
This electric power tool complies with national and international standards and
safety requirements. Repairs should only be carried out by qualified persons
using original spare parts. Failure to do so may result in considerable danger to
the user.
If using the power tool inside your house, protect furnishings and floors with a
suitable dust sheet.
Always observe general fire safety precautions when using certain power tools
inside your house or workshop. It is recommended that you have an appropriate
fire extinguisher available at all times while working.
19.2V Cordless Drill