Steele Products SP-PB008 - Manual (Page 3)

WARNING: IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS
PROPERLY GROUNDED. IF YOU ARE NOT SURE HAVE A QUALIFIED ELECTRICIAN CHECK THE
RECEPTACLE.
DO NOT MODIFY THE PLUG PROVIDED.If it will not fit the outlet,
CONNECTION of the equipment ground conductor can result
If repair or replacement of the electric cord or plug is necessary,
EXTENSION CORDS
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire
extension cord which has a 3-prong grounding type plug and matching receptacle which will accept
the machine's plug. When using an extension cord, be sure to use one heavy enough to carry the
current of the machine. An undersized cord will cause a drop in line voltage, resulting in loss of power
and overheating.The table , shows the correct gauge to use depending on the cord length. If in doubt,
use the next heavier gauge. The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINE~
Ampere Total Length Gauge of
Rating Volts of Cord in Feet Extension Cord
0-6 120 up to 25 18 AWG
0-6 120 25-50 16 AWG
0-6 120 50-100 16 AWG
0-6 120 100-150 14 AWG
6-10 120 up to 25 18 AWG
6-10 120 25-50 16 AWG
6-10 120 50-100 14 AWG
6-10 120 100-150 12 AWG
10-12 120 up to 25 16 AWG
10-12 120 25-50 16 AWG
10-12 120 50-100 14 AWG
10-12 120 100-150 12 AWG
12-16 120 up to 25 14 AWG
12-16 120 25-50 12 AWG
12-16 120 GREATER THAN 50 FEET NOT RECOMMENDED
GENERAL SAFETY INFORMATION
4
have the proper outlet installed by an electrician.IMPROPER
in risk of electric shock. The conductor with the green insulation
(with or without yellow stripes) is the equipment grounding conductor.
DO NOT connect the equipment grounding conductor to a live terminal
a live terminal
UNPACKING
After unpacking the unit, inspect all components for any damage that may have occurred in transit.
Read the following precautions and instructions before you attach. Failure to comply with these
instructions could result in personal injury or property damage. Keep these instructions in a convenient
location for future reference.The following items are included with your bench grinder.
Tool Rest (Left & Right) & Adjusting Knob
lf any parts are missing do not operate this tool until the missing parts are
replaced. Failure to do so could result in possible serious personal injury.Call 888-896-6881
for replacement parts.
GENERAL SAFETY INFORMATION
5
Eyeshields (Plain & with Magnifier)
Eyeshields Mounting Hardware Kit
WARNING