Steele Products SP-CE358TM - Manual (Page 21)

21
Owner’s Manual
Compressor (cont’d)
BREAKING IN THE PUMP
1.Turn the switch to the OFF position.
2. Open the petcock. Turn counterclockwise (loosen).
3. Plug in the power cord and turn switch to the ON position.
4. The compressor will start.
ALLOW THE COMPRESSOR TO RUN FOR 15 MINUTES, TO BREAK IN THE
INTERNAL PARTS.
CAUTION: after about 15minutes .If the unit does not operate properly.Shut
down immediately, and contact product service center.
5. After about 15 minutes, turn the power switch to the OFF position.
6. Close the petcock. Turn in the clockwise direction.
7. Turn the power switch to the ON position .The compressor will start and fill the tank
to the kick-out pressure and stop.
Note: As compressed air is used, the pressure switch will restart the motor
automatically.
Note: During the initial break-in cycle, there will be a slight electrical smell as
the motor brushes seat .This is normal for universal motors and will last for about 5
minutes.
OPERATING INSTRUCTIONS
Daily Startup
1. Turn the power switch to the OFF position.
2. Close the tank petcock. Turn in the clockwise direction.
3. Plug in the power cord.
4. Turn the power switch to the ON position
Make sure to put oil in the crankcase before you start the air compressor.