ARB 4413270 - Manual (Page 3)

11-01-06 Page 3 of 4 3783019
5. Fit the rear of the front rail into the front
step. Using the M8 hardware, bolt the front
rail to the side step (finger tight at this
stage).
6. “G” clamp the bull bar clamps to the front of
the side rail and bull bar. Once the rail is
aligned to the front guard of the vehicle,
tighten the M8 bolt in the lower bracket then
drill and pin through the side step bracket to
lock the front rail into position using the M8
bolt and hardware supplied.
The mud flaps may need to be removed to
drill and pin the bracket, the wheel will
also need to be turned outboard to
provide sufficient access.
Ensure the side step and front rail tubes are
butted together firmly with no gap before
fastening tightly.
7. Drill thought the side rail and rail clamps
using a 8.5 mm drill bit and fasten with the
black M8 coach bolts and hardware supplied.