ARB 3915020 - Manual (Page 7)

05/01/04 Page 7 of 9 3783077
16.
24. The rubber extrusion contains a support section
to assist in the moulding. Remove this section
by tearing at one end. Discard this section.
25. Insert the square plastic plugs into the square
holes on the top face of the wing.
17.
26. Insert the mount strips inside the channel
section of the rubber extrusion. Make sure the
flap section is on the outer side. Allow generous
even amounts of excess at either end of the strip
so that it can be trimmed later.
18
27. Using a phillips head screw driver or cordless
drill with a phillips head tip fix the extrusions to
the top of the wings using the self taper screws.