ARB 3932020 - Manual (Page 8)

13/6/08 Page 8 of 11 3786950
20. Fit control box bracket to bar using 8mm
hardware.
21. Fit winch into bar using 1 1/2” x 3/8”
bolt on top holes and 1 ¾” x 3/8” bolt on the
lower holes plus 25mm large flat washers and
spring washers.
Cable spools from bottom of winch.
When fitting roller fairlead to bar,
remove circlips and push vertical
pins upward to move the vertical
rollers sideways to enable you to
place a socket to the bolt. When all
bolts are fitted replace vertical
pins and circlips.