ARB 3444060 - Manual (Page 3)

25/1/02 Page 3 of 4 3782586
DIAGRAM 1 DIAGRAM 2
3. To place the winch motor in the correct location the winch motor must be rotated 90 degrees, in a clockwise
direction when viewed from the motor end. Place the winch on its end and remove the two motor retaining
bolts. Gently raise the motor just enough to rotate it. Do not completely remove the motor and avoid damaging
the gasket. Refit all bolts and tighten. (Refer to diagram 2.)
4. The roller fairlead must have new holes drilled to allow for correct wire rope angle. Using a 12mm diameter
drill bit, redrill the roller fairlead as shown. (Refer to diagram 3.)
DIAGRAM 3
5. Fit the control box to the control box bracket using the two 1/4” nuts, flat washers and spring washers (supplied
in Warn kit). Centralise the control box in the cut-out then tighten nuts firmly.
6. Fit the control box bracket to the bull bar using two M6 x 20mm dome head bolts, flat washers and flange nuts.
7. Fit the winch and roller fairlead into the bull bar using bolts from the winch kit and four M10 washers from the
ARB bolt kit.
8. Connect the winch control box cables to the winch motor. Refer to the Warn handbook for additional
information. Connect the long winch + & - cables to the vehicle after the bull bar is installed. Refer to the
Warn winch manual for vehicle wiring instructions.
9. NOTE: Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the winch
cables to the bull bar with the cable ties supplied.