ARB RD145 - Manual (Page 16)

3 Installing the Air Locker
14
3.6 Profiling the Seal Housing Tube
Without using sharp, jagged tools such as pliers (your hands are
the best tool for this job), gently bend the seal housing tube so that
it runs in a loop beside the flange cap and out through the tapped
bulkhead port as shown in Figures
9. , 10. , and 11.
NOTE : It is a good idea to cable tie the tube to the seal
housing bracket to keep it from contacting anything
inside the housing.
Figure 9.
Figure 10.