ARB RD158 - Manual (Page 6)

1 Introduction
4
1.2 Tool-Kit Recommendations
Below is a list of tools and supplies you may need to complete this
installation. Requirements for your vehicle may vary. Please consult
your vehicle service manual for additional recommendations.
1.2.1 Tools
 Standard automotive sizes (metric and/or imperial) of sockets,
wrenches, Allen keys, and drills.
 A dial indicator or other suitable measuring tool for checking ring &
pinion backlash.
 An automotive brake tubing cutter to cut the copper tube.
 A razor knife to cut the nylon tubing.
 A differential housing spreader (e.g. ARB Spreader #0770003, if
applicable), to facilitate removal of the carrier. (not required on
aluminum housings)
 A torque wrench. (See vehicle manual for required torque range.)
 A lubricant drain reservoir.
 Suitable measuring tools to measure a differential for pre-load
and/or backlash shimming. (e.g. automotive feeler gauge. See
Section 4.5)
 An 11.2mm [7/16”] drill and ¼” NPT tap for bulkhead fitting
installation.
 An automotive bearing puller (e.g. ARB Bearing Puller #0770001)
or a differential carrier bearing puller.
 A bearing press or arbor press.
 A suitable shim driver (e.g. ARB Shim Driver #0770004).
 A soft hammer (e.g. raw hide or nylon)
1.2.2 Supplies
 Thread lubricant/sealant compound (e.g. LOCTITE #567 Teflon
Paste)
 Thread locking compound (e.g., LOCTITE #272)
 A replacement gasket, or gasket sealant, for your differential cover.
 A sufficient volume of differential oil to completely refill your
housing. (see the ARB Air Locker Operating and Service Manual
for recommended lubricants)
 A soap and water mixture to test for air leaks.