beautypg.com

1 introduction, Tool-kit recommendations, Tools – ARB RD104 User Manual

Page 6: Supplies

background image

1 Introduction

4

1.2

Tool-Kit Recommendations

Below is a list of tools and supplies you may need to complete this
installation. Requirements for your vehicle may vary. Please consult
your vehicle service manual for additional recommendations.

1.2.1

Tools

c Standard automotive sizes (metric and/or imperial) of sockets,

wrenches, Alan keys, and drills.

c A dial indicator or other suitable measuring tool for checking ring &

pinion backlash.

c A standard automotive feeler gauge.
c A razor knife to cut the nylon tubing.
c A differential housing spreader, to facilitate removal of the carrier.

(not required on aluminum housings)

c A torque wrench. (See vehicle service manual for required torque

range.)

c A lubricant drain reservoir.
c Suitable measuring tools to measure a differential for pre-load

and/or backlash shimming. (See Section 3.3)

c A 11.2mm [7/16”] drill and ¼” NPT tap for bulkhead fitting

installation.

c An automotive bearing puller (2 jawed is recommended) or a

differential carrier bearing puller.

c A bearing press or arbor press.

1.2.2

Supplies

c Thread lubricant/sealant compound for pressure fittings

(e.g., LOCTITE #567 Teflon paste)

c Thread locking compound (e.g., LOCTITE #272)
c Either a replacement gasket, or gasket sealant, for your differential

cover.

c A sufficient volume of differential oil to completely refill your

housing. (see the ARB Air Locker Operating and Service Manual
for recommended lubricants)

c A soap and water mixture to test for air leaks.
c Teflon paste.