Behringer HA4400 User Manual

Page 12

POWERPLAY PRO HA4400

Fig. 5.1: Example of a studio playback application

5.2.1 Using the amplifiers as independent power amplifiers
In addition to the joint control of all channels via the MAIN input, each of the four power amplifiers can also be

used independently. The AUX IN inputs in combination with the BALANCE controls serve this purpose.
If the BALANCE control is set to its clockwise stop position (position AUX), the MAIN signal is muted; only

the input signals applied to the AUX IN input are routed to the power amplifier. By configuring the amplifiers as

completely independent power amplifiers, you can insert up to four independent stereo programme sources;

thus, four different and individual mixes for up to four musicians can be created. As with a stage monitor

system, you can give each musician a specific configuration of instruments and create a personal mix for him

or her that is musically inspiring. Or you can set up different signal paths for the interpreters in a conference

system.
Configure sub-groups or create pre-mixes using the effects and/or monitor facilities of your mixing console.

Fully turn up the BALANCE control and connect the AUX inputs of the BEHRINGER POWERPLAY PRO to the

corresponding monitor, sub-group or single outputs of the mixer.

Fig. 5.2: Example of monitor inserts in a stage application

5. APPLICATION