Bissell 7901 - Manual (Page 8)

8
Tank-in-Tank Continued
Lift the Tank-in-Tank handle. The handle locks the
lid in place.
Carry it like a bucket to fill at the sink.
Note: You may notice hair and debris deposits on
the carpet that were loosened by the
brushing action (especially with newer
carpets that have never been deep cleaned
before). This debris should be picked up
and thrown away. Debris that deposits in
the Brush Belt should be cleaned between
uses to keep the Belts running free.
Set the tank down and rotate the handle forward to
unlatch the lid. Lift off and set the lid aside.
Find the mouth of the Bladder and fill to the bottom of
the neck with clean hot tap water. *Do not boil or
microwave water as it can destroy the Bladder.
Note: Fill the Bladder with clean hot tap water only.
Replace the tank lid matching the lid and tank edges.
Handle must be in the forward position to reinstall.
Rotate the handle to the carrying position to re-latch
the lid.
Replace tank in machine base, seating firmly in place.
Rotate handle back down to the latched position.
Note: Both the SmartMix Bottle and the clean
water tank must have liquid in them in
order for the machine to spray. If one tank
is empty the machine will not apply either
cleaning solution or water only.
Remove the Tank-in-Tank – follow steps 1 and 2
on page 7 and 8.
Carry the Tank-in-Tank, like a bucket, to the sink where
you will dispose of the dirty water.
2.
3.
4.
5.
6.
7.
8.
9.
Lift and Carry
Fill bladder only with
clean hot tap water
Rotate Handle to
Unlatch
When It’s Time to Empty Tank-in-Tank
1.
2.
Latched
3
4
5
9