Philips 8P6054C - Manual (Page 14)

STOP ■
REW
ᮤᮤ
FF
ᮣᮣ
PLAY ᮣ REC ● STATUS
VOL CH
1 2 3
4 5 6
7 8 9
0
ON/OFF
TV/VCR
VCR CBL TV
SWAP FREEZE POS
SIZE
ENTER
MENU
M
CLEAR
؀ ؁
SURF MUTE
PAUSE II
SLEEP
SMART
POWER
M O D E
LIGHT
2 TUNER PIP
B ᮤ ᮤ A
EXIT
1 OF 5
PICTURE
SOURCE
MORE...
CLOSED
CAPTIONS
FEATURE MENU
CHANNEL
MEMORY
CABLE
TUNING
MAIN MENU
PICTURE
FEATURES
SOUND
HELP
EXIT
EXIT
ADD/DELETE
CHANNELS
START
AUTO-PROGRAMMING
CHANNEL MEMORY
HELP
Channel 19 Added
for ANT A
to DELETE CHANNEL
when FINISHED
SELECT CHANNEL
M
2
3
4
1
1
ADD/DELETE CHANNEL
for ANT B A B
1ST TIME SETUP
F
EATURE
M
ENU
C
ONTROLS
(
CONTINUED
)
A uto-Programming (see
previous page) adds all the
channels it can find (on your
Antenna or Cable TV system) into
the TV's memory. Add/Delete
Channels makes it easy for you to
add other channels, or drop
unwanted channels, from the list of
channels in the TV's memory.
Select CHANNEL MEMORY
(ADD/DELETE CHANNELS)
control.
With the FEATURES MENU on
screen, move the RED highlight
with the MENU (M) buttons.
Then press the MENU button.
Press the CHANNEL ▲▼ or
number buttons to select the
channel you want to add or delete.
Press the MENU ᮣ button to
ADD the channel into the TV's
memory.
Press the MENU ᮤ button to
DELETE the channel from
memory.
Repeat steps 2 and 3 for each
channel you wish to add or delete.
Press the STATUS or MENU
button to clear the screen when
through.
ADD/DELETE CHANNELS
STOP
1
2
3
4
S
MART
H
ELP
Remember. You can also
add the AUX 1, AUX 2, or
AUX 3 modes just like a channel.
Then by pressing the CHANNEL
▲▼ buttons the AUX(iliary)
mode can quickly be selected to
use the desired set of Input jacks
on the TV (see page 28).
Note: AUX 1, AUX 2, and AUX 3
modes are located between the
lowest and highest channel
numbers within the
ADD/DELETE CHANNEL
control screen.
BEGIN
NOTE: A separate ADD/DELETE CHANNEL memory
may also be created for the ANT(enna) B Input on the
rear of the set (if an Antenna or Cable TV signal has been
connected). Just press the button on the remote,
while in the ADD/DELETE CHANNEL mode, to switch
between the ANT A and ANT B channel memory lists.
Then follow steps 2 and 3 as shown to the left to add or
delete the desired channels.
B ᮤ ᮤ A
14