Turning on the tv/vcr 9 – Philips CCB092AT User Manual

Page 9

Turning On the TV/VCR 9

Before you turn on the TV/VCR, make sure batteries are in the
remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.

Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.

Press the PLAY/K button or the STOP/L button to select
English or Spanish on-screen displays and menus.

Press the MENU button. The screen shown below will appear.

Press the F.FWD/B button to begin automatic channel
setup. The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on the screen
briefly. Then the TV/VCR will go to the lowest channel pro-
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on
the TV/VCR, then press the F.FWD/B button again. You may
need to follow the steps on page 11 instead.)

CONNECT ANTENNA OR CABLE
TO TVCR

THEN PRESS B

TO END PRESS EXIT

SELECT LANGUAGE

> ENGLISH ON

ESPAÑOL

SELECT KL OR
PRESS MENU TO CONTINUE

Use the CH(annel) m

button or the Number buttons

on the remote control to select a TV/VCR channel. Use
the VOL(ume) m

button to adjust the sound.

• If you do not see any on-screen dis-

plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
10-11 to select a language and set
up channels.

• To skip step 2, press the MENU

button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS
NOT SET will appear on the screen
briefly.

• You cannot set up channels if you

are using a Cable Box.

• Line Input mode will always be

stored in the TV/VCR’s memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on the
screen briefly. Press the CH(annel)
m

button or the Number but-

tons to select another channel.

Helpful Hints

1
2

VOL.

CH.

POWER

STATUS/EXIT

TRACKING

REC/OTR

SPEED

MEMORY

ALT. CH

PAUSE/STILL

MUTE

F.FWD

REW

PLAY

STOP

SLEEP/WAKE UP

CLEAR