Philips 230WP7NS-27 - Manual (Page 67)

Setting up and Connecting Your Monitor
If you use an Apple Macintosh TM , you need to connect the
special Apple Macintosh adapter to one end of the monitor signal
cable.
Connect the cables to the back of your computer by following these steps:
(a) Turn off your computer and unplug its power cord.
(b)
Connect the monitor signal cable to the video connector on the back of your
computer.
(c) Plug the power cord on your computer and your monitor into a nearby outlet.
(d) USB plug
(1) Connect USB upstream port on monitor and the USB port on PC with a USB
cable.
(2) The USB downstream port is now ready for any USB device to plug in
(e)
Turn on your computer and monitor. If the monitor displays an image, installation is
complete.
Note: The USB plug is a pass through connection whether it can support USB 1.1 or
USB 2.0 depends on your PC's specification.
RETURN TO TOP OF THE PAGE
file:///D|/My%20Documents/dfu/230WP7/english/230wp7/install/connect.htm (2 of 2)2006-01-10 3:35:04 PM