Philips PR1920C - Manual (Page 6)

6
75 ⍀
75
⍀
1
2
A combination antenna receives
normal broadcast channels
(VHF 2-13 and UHF 14-69).
Your connection is easy since
there is only one 75
Ω
(ohm)
antenna plug on the back of your
TV - and that’s where the antenna
goes.
If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the TV.
If your antenna has flat twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300 to 75 ohm adapter.
Push the round end of the
adapter (or antenna) onto the 75
Ω
plug on the rear of the TV. If the
round end of the antenna wire is
threaded, screw it down tight.
H
OOKING
U
P
Y
OUR
TV (B
ASIC
A
NTENNA
TV C
ONNECTIONS
)
BEGIN
A
NTENNA
Remember:
Be sure to set the
TV for the type sig-
nal you've connect-
ed (see the “Tuner”
section on page 11
of this manual.)
To set the TV to
select only the chan-
nel numbers in your
area see how to
“Program" or "Add"
channels in the TV’s
memory on page 12
(Auto Program sec-
tion).
To order any option-
al accessory contact
your dealer or the
Philips Parts Center
at 1-800-851-8885.
S MART
H ELP
300 to 75
Ω
Adapter
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable
75
Ω
Back of TV
OR
Note: For homes with separate UHF and VHF antennas
you will need an optional combiner to connect to the TV.
U/V
Combiner
75-300 Ohm Adapter
Back of TV